Supplies:
Plastic Wet Wipe case, there are several different styles I’ve seen but mine is a Huggies brand
Fabric (Link to my Fabric here)
Cotton Batting
Ribbon for the edges
Scissors or X-acto Knife
Hot Glue Gun
Roughly cut fabric out, large enough to fold over the wet wipe case edges. You can trim the excess later.
Glue the cotton batting down, beginning at the front and working around to the back. Be careful to not glue inside the area where the lids close together. After gluing trim the excess using scissors or X-actio whichever works best for you.
Glue your top layer over the batting. Following the same procedure as when you applied the batting. I used a clip to keep my fabric in the right position while gluing.
Trim excess fabric. It doesn’t have to look perfect since the ribbon will cover the edges.
Glue your ribbon starting at the back.
When you reach the opposite side, make a U-turn and proceed to cover the other lid.
After you cover both lids, clip your ribbon and glue down the end.
No comments:
Post a Comment
Thank you for taking the time to leave a comment. All comments are moderated. So if your comment doesn't show up immediately don't worry, it's just waiting for approval before posting. I don't approve comments that are spam like, inappropriate or malicious. Constructive criticism is welcome, incivility is not. This is a place to have fun! I try to respond to most questions, if I don't respond it's usually because it has been asked before and already answered. Thanks for stopping by!